86-025-5119 7362
English
日本語
한국어
français
Deutsch
Español
italiano
русский
português
Türkçe
Nederland
I raccordi senza flangia Pre-torque offrono una connessione unica per i raccordi a tenuta manuale con clic quando la resistenza del cappuccio aumenta fino a raggiungere la coppia corretta, È realizzato in materiale PP o PTFE e viene fornito con un dado pre-torque e una ghiera per il trasferimento di gas o liquidi. QuestiRaccordi filettatiSono disponibili per tubi diametri esterni di 1.6/2.0/2.5/3.0/3.2mm.
Nut Specification
Ferrule Specification
Color | Blue | Yellow | Red | ||||
Nut |
|
|
|
|
|
|
|
Torque Range | 0.11-0.15N/m | 0.15-0.20N/m | 0.20-0.25N/m | ||||
Operating Environment | Room Temperature and Pressure Tube wall thickness≤0.5mm | Room Temperature and Pressure Tube wall thickness＞0.5mm | Temperature＜100℃ Pressure＞0.8Mpa Tube WT＞0.5mm | ||||
Dimension (unit: mm)
1. Choose 1/4-28 nut when receiving port is 1/4-28; Choose M6 nut when receiving port is M6.
2. Before connecting fittings, ensure the end of the tubing has a clean, square, burr-free cut. This is very important, as the square cut helps the tubing make full contact with the bottom of the mating port. Neglecting to properly cut the tubing could lead to dead volume, resulting in peak distortion such as fronting, tailing or broadening.
3. Two-Piece Fittings Installation Steps:
a. Slide the nut, followed by the ferrule, at least 3/16” (4.7625mm) from the end of the clean cut tubing
b. Insert the assembly into the receiving port, pushing the tubing into the port until it bottoms out.
c. Finger or wrench tighten the fittings until the cap comes out "click" which means properly tightened
d. After several uses (especially at high pressure) the ferrule should be replaced.
